Yamaha TT-R125(P), Руководство по эксплуатации для владельца

Страница: 204 / 509

3 - 27
INSP
ADJ
STEERING HEAD INSPECTION AND ADJUSTMENT
T
R
.
.
Ring nut (final tightening):
20 Nm (2.0 m • kg, 14 ft • lb)
●
Check the steering stem by turning it lock
to lock. If there is any binding, remove the
steering stem assembly and inspect the
steering bearings.
●
Install the rubber washer 8 , upper ring
nut 9 and special washer 0 .
NOTE:
●
Tighten the upper ring nut until it contacts
the rubber washer.
●
Insert the special washer pawls into the
slots. If the slots are not aligned, tighten
the upper ring nut for alignment.
●
Install the upper bracket A , steering stem
nut B , cap C , handlebar D , upper han-
dlebar holder E , starter knob nut F and
number plate G .
NOTE:
●
The upper handlebar holder should be
installed with the punched mark
a
for-
ward.
●
Insert the end of fuel breather hose H into
the hole of the starter knob stay.
CAUTION:
First tighten the bolts on the front side of
the handlebar holder, and then tighten
the bolts on the rear side.
T
R
.
.
Pinch bolt (upper bracket):
25 Nm (2.5 m • kg, 18 ft • lb)
Steering stem nut:
110 Nm (11.0 m • kg, 80 ft • lb)
Handlebar upper holder:
23 Nm (2.3 m • kg, 17 ft • lb)
Starter knob nut:
1 Nm (0.1 m • kg, 0.7 ft • lb)
Number plate:
7 Nm (0.7 m • kg, 5.1 ft • lb)