Yamaha SY99, Руководство пользователя

Страница: 156 / 344

VOICE EDIT MODE
AFM ELEMENT DATA
4. (F2) AFM operator output (All)
JUMP #242
Summary: Set operator output level while viewing
output levels for all operators. (Output scaling
cannot be set in this job.)
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 04:0utput and press (JUMP #242)
F2 (All)
Specify: the output level of each operator
Output Level OP1-OP6 (0...127): Set the out-
put level of each operator. This is the same set-
ting as explained in
4. ( F 1 ) AFM operator output. The difference is
that here you can view and set the output level
for all six operators at once. However, break
point Levels and Offsets Cannot be set here.
of the previous section
Remarks: Refer to 4. (F1) AFM operator output
for details.
Note: In algorithms with two or more carriers, some
Velocity Sensitivity settings may cause distor-
tion. In this case, reduce carrier levels.
AFM ELEMENT DATA
5. AFM sensitivity
JUMP #243
Summary: These settings determine how each
operator will be affected by key-on velocity and
by the LFO.
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 05:Sensitv (JUMP #243)
Specify: the sensitivity of each operator
Velocity (-7...+7): This determines how the
output level of each operator will be affected by
key-on velocity. For positive settings (+1...+7)
the output level will increase as you play more
strongly. For negative settings (-1...-7) the
output level will decrease as you play more
strongly.
Rate Velocity (on/off): When the Rate Velocity
switch is "on", key-on velocity will affect the
operator EG Rl. The result will depend on-the
Velocity setting.
Velocity = +1...+7: If Rate Velocity is on,
strongly played notes will cause the operator
EG Rl to increase, resulting in a faster attack.
For notes played with maximum velocity, Rl will
be at the value specified by the EG settings.
Velocity = -1...-7: If Rate Velocity is on,
strongly played notes will cause the operator
EG R1 to decrease, resulting in a slower attack.
To hear the effect of negative settings you will
need to lower the operator output level.
When the Rate Velocity switch is "off", the
operator EG Rl will not be affected by key-on
velocity.
AModSens (0...7): Amplitude Modulation
Sensitivity determines how greatly the output
level of each operator will be affected by Ampli-
tude Modulation from the LFO.
PModSens (0...7): Pitch Modulation Sensitivity
determines how greatly the pitch of each oper-
ator will be affected by Pitch Modulation from
theLFO.
Pressing F1 (KVS), F2 (Rate), F3 (AMS), or F4
(PMS) will move the cursor to Velocity, Rate
Vel, AModSens, or PModSens.
145