Yamaha SY99, Руководство пользователя

Страница: 113 / 344

VOICE EDIT MODE
COMMON DATA / ELEMENT DYNAMIC PAN
6.2 Pan EG
Summary; Specify how the element will be panned
over time, starting when each note is played.
Procedure:
From: Dynamic Pan Edit job directory
Select: 02:PanEG.
Press: F1 (Rate) to set pan EG rates.
Press: F2 (Lvl) to set pan EG levels.
SLP (Loop Point S1-S4): This specifies the
segment from which the EG will continue looping
if a key remains depressed after the EG has
come to the end. Refer to the following diagram.
The number and name of the currently selected
Dynamic Pan data are displayed.
This indicates the displayed segment and range
of the EG graphic display. To change the range,
hold SHIFT and press F1-F6 (x1, x2, x5, x10, x20,
x50). To shift the EG graphic display to a dif-
ferent segment, hold SHIFT and press F7 or F8 to
select Seg0-Seg4, Rel1.
The pan EG is graphically displayed.
Press Fl (Rate) to set EG rates. Press F2 (Lvl)
to set EG levels.
HT (Keyon Delay Time 63...0): When this is set
to 0, the pan EG will begin immediately after a
key is pressed. For higher settings, there will be
an increasingly longer delay before the pan EG
begins.
R1-R4, RR1-RR2 (Keyon Rates, Release Rates
0...63): Keyon Rates and Release Rates 1-
2 determine the speed of the pan EG. Higher
settings result in faster change. Refer to the
diagram below.
L0-L4, RL1-2 (Keyon Levels, Release Levels
-32...+32): Keyon Levels 0-4 and Release
Levels 1-2 determine the panning direction and
distance of the pan EG. Negative settings move
left, and positive settings move right. Refer to
the following diagram.
102
When you press a key, the sound will be output at
the pan position of L0. When the specified hold time
(HT) has elapsed, the pan position will change at
the rate of R1 to level L1. When the pan position
reaches L1, it will change at the rate of R2 to the
position of L2. When the pan position reaches L2, it
will change at the rate of R3 to the position of L3.
When the pan position reaches L3, it will change at
the rate of R4 to the position of L4. When the pan
position reaches L4, the EG will begin looping from
the specified segment (in the above diagram,
SLP=S3).
When you release the key, the pan position will
change at the rate of RR1 to the position of RL1.
When the pan position reaches RL1, it will change
at the rate of RR2 to the position of RL2.
Remarks: Hold Time (HT) is a time setting, but
the various Rates are speed. Higher settings for
Hold Time will result in a longer delay before the
pan EG begins, but higher settings for Rates will
result in faster change. The final result of the
Pan EG will depend on the Pan Source settings.