36
En
Optimizing the speaker setting for your listening room
y
It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears
would be when you are seated in your listening position.
You can use the attached screw of a tripod (etc.) to fix the
optimizer microphone to the tripod (etc.).
3
Press
9
ENTER
to start the measurement.
This unit starts to count down from 10 seconds.
y
• To start the measurement immediately, press
9
ENTER
again.
• To cancel the automatic setup and return to the previous
screen, press
?
RETURN
and then
9
ENTER
.
Loud test tones are output from each speaker during
the measurement. Once all items are measured,
“COMPLETED” appears.
If an error or warning message appears, see “Automatic
setup” (page 145).
4
Disconnect the optimizer microphone to
complete the automatic setup.
y
You can check the results of the measurements by using
the GUI screen (page 40).
Use this feature to optimize the setup of this unit for one
listening position. You can also select the parameters to be
optimized in the automatic setup.
1
Turn on the video monitor and then follow
steps 1 and 2 in “Quick automatic setup”
(page 35).
2
Press
I
MENU
on the remote control.
The following screen (GUI menu) appears in the
video monitor.
3
To select the parameters to be optimized,
press
9
k
to select “Setup Menu” and then
press
9
h
.
When you do not need to select the parameters to be
optimized, skip to step 6.
y
If you do not select the parameters to be optimized, this
unit will optimize the parameters you selected last time.
All the parameters except “Angle” are selected by the
initial factory settings.
4
Press
9
k
/
n
repeatedly to select the
parameter and then press
9
ENTER
to
check or uncheck the box.
Check the boxes for the parameters to be optimized.
Before proceeding next operation
Once you perform the next operation, this unit starts the
automatic setup procedure in 10 seconds. During the automatic
setup procedure, do not perform any operation on this unit. For
more accurate measurements, we recommended that you get out
of the room or move to the wall where speakers are not around
during the measurement. It takes approximately 3 minutes.
Note
Optimizer microphone
C O M P L E T E D
P L S U N P L U G M I C
E R R O R : E - 0 1
P R E S S E N T E R
Basic automatic setup
Parameter
Descriptions
Multi Measure
(Multiple point
measurement)
You can optimize the setup of this unit for
multiple listening positions. For details, see
“Advanced automatic setup” (page 38). In
the basic automatic setup, leave this setting
to the default.
Wiring
(Speaker wiring)
This unit checks and adjusts which speakers
are connected and the polarity of each
speaker.
Distance
(Speaker distance)
This unit checks and adjusts the distance of
each speaker from the listening position and
adjusts the timing of each channel.
Size
(Speaker size)
This unit checks and adjusts the frequency
response of each speaker and sets the
appropriate low-frequency crossover for
each channel.
Information
Setup Menu
Start
NOTICE
Loud test tones are
output.
Please keep quiet
or leave the room.
Start:ENTER
