PM1D System Software V1.6 Supplementary Manual
10
2. In the LIST SELECT area (
1
), move the cursor to
the DCA button and press the [ENTER] switch.
The name list (
2
) will show a list of the long names
(eight characters) assigned to each DCA group.
3. In the name list, move the cursor to the column of
the desired DCA group.
4. Make sure that the cursor is located at the first
character of the text box (
3
) at right, and click the
DCA AUTO NAMING button of the character pal-
ette (
4
).
A highlighted “D” character will be input into the
character palette.
Hint
•
If a PS/2 keyboard is connected to the CS1D, you
can also type Ctrl + D to input the highlighted “D”
character. (As a shortcut, you can hold down the
Ctrl key and type the first character of the button
name in the character palette.)
•
When you input the highlighted “D,” no further
characters can be input into the text box. Also, any
previously-input characters will be deleted.
•
To delete the highlighted “D,” click the CLEAR
button.
5. Click the ENTER button at the right of the charac-
ter palette.
A highlighted “D” character will be input in the long
name field of the name list.
The Auto Naming function is now enabled for the
corresponding DCA group. At this time, the DCA
[NAME] indicator will go dark if a channel has not
been assigned to the corresponding DCA group.
6. As necessary, perform the same operation for other
DCA groups.
7. Assign channels to the DCA groups for which you
performed steps 3–6.
For example if you assign input channels 1 and then
2 to DCA group 1, the corresponding DCA [NAME]
indicator will show the channel names of input chan-
nels 1/2.
If you then add input channel 3 to the same DCA
group, the DCA [NAME] indicator will change as
follows.
•
Be aware that when you use the DCA Auto Nam-
ing function, the DCA [NAME] indicator will
show the short names of the two last-assigned
channels.
•
A maximum of twelve channels of names will be
remembered for a DCA group. If a paired chan-
nel is assigned, the lower-numbered channel will
be displayed above.
•
If you remove input channel 3 from DCA group 1
in the example described above, the display will
be blank.
Hint
•
If you turn on the UNIT NAME button in the
NAME MODE area at the bottom of the screen,
the DCA [NAME] indicator will show the name of
the port assigned to that channel, instead of show-
ing the short name of the input channel.
•
If you turn Cue Monitor on for a DCA group for
which Auto Naming is enabled, the channel that
was last assigned to that DCA group will be
selected (its [SEL] key will light).
Channel
names
Channel
names
