MOXF6/MOXF8 Reference Manual
Voice Mode
32
This is a parametric EQ featuring three bands (High, Mid and Low). You can attenuate or boost the level of each
frequency band (High, Mid, Low) to change the Voice sound.
FREQ (Frequency)
Determines the frequency for each frequency band.
Settings:
Low: 50.1Hz – 2.00kHz
Mid: 139.7Hz – 10.1kHz
High: 503.8Hz – 14.0kHz
GAIN
Determines the level gain for the Frequency (set above), or the amount the selected frequency band is attenuated or
boosted.
Settings:
-12.00dB – +0.00dB – +12.00dB
Q
Determines the Q (bandwidth) for the Mid band.
Settings:
0.7 – 10.3
[SF1] SET1/2 – [SF3] SET5/6
Since up to six Controller Sets can be assigned to each Voice, three pages (Sets 1/2, Sets 3/4 and Sets 5/6) are
available. For details on Controller Set, see
ElmSw (Element Switch)
Selects whether the controller will affect each individual Element or not.
Settings:
Elements 1 to 8 enabled (“1” to “8”) or disabled (“-”).
NOTE
This parameter is disabled when the Dest (Destination) described below is set to a parameter unrelated to the Voice Elements.
Source
Determines which controller is to be assigned to and used for the selected Controller Set. This controller then is used to
control the parameter set in Destination below.
Settings:
PB (Pitch Bend wheel), MW (Modulation wheel), AT (Aftertouch), FC1/FC2 (Foot controller 1/2), FS (Foot Switch), RB (Ribbon
Controller), BC (Breath controller), AS1 (ASSIGN 1), AS2 (ASSIGN 2), FC2 (Foot Controller 2), AF1 (ASSIGNABLE FUNCTION
[1]), AF2 (ASSIGNABLE FUNCTION [2])
NOTE
When the foot switch is set to a Control Change number of 96 or higher in the CTL ASN display of the Utility mode, the foot
switch will not be available as a “Source” of the Controller Set for the selected Voice.
Dest (Destination)
Determines the function that is controlled by the controller set in “Source.”
Settings:
See the “Control List” in the “Data List” PDF document.
Depth
Determines the degree to which the Source controller affects the Destination.
Settings:
-64 – +0 – +63
[F3] EQ
[F4] CTL SET (Controller Set)