60H5E11
3
Engine idle speed : 675-725 r/min
Control system
3-16
3. Check that the accelerator cam
3
is
aligned with the centerline of the roller
4
.
60H30390
4. Loosen the throttle lever tightening screw
5
clockwise to make the accelerator cam
aligned with the centerline of the roller
4
.
5. Tighten the throttle lever tightening screw
5
counterclockwise.
NOTE:
The throttle lever tightening screw
5
has left
hand threads.
6. Start the engine and adjust the engine idle
speed by turning the idle adjusting screw.
Adjusting the choke solenoid
1. Remove the intake silencer.
2. Make sure that the choke valve is fully open.
3. Check that the choke solenoid face
A
is
between the marking
B
on the plunger.
Adjust the position of the choke solenoid if
necessary.
60H30400
Adjusting the throttle link and the
throttle cable operation
NOTE:
Complete the ignition timing adjustment,
throttle valves synchronization, engine idle
speed adjustment, and carburetor pickup tim-
ing adjustment prior to the throttle link adjust-
ment.
1. Loosen the locknut
1
, remove the clip
2
,
and disconnect the throttle cable joint
3
.
60H30410
2. Adjust the length of the throttle cable joint
3
so that its hole is aligned with the set
pin on the magnet control lever.
60H30415
60H30420
The throttle cable joint must be screwed in
a minimum of 8.0mm (0.31in.)
A
.
Содержание 200A
