60H5E11
Lower unit
LOWR
E
Installation depth
A
:
20.95 - 21.45 mm(0.8248 - 0.8445 in)
Installation depth
B
:
4.45 - 4.95 mm(0.1752 - 0.1949 in)
6-49
Checking the reverse gear
1. Check the teeth and dogs of the reverse
gear for cracks or wear. Also check the
bearing for run-out and roughness.
2. Remove the needle bearing.
60h60380
NOTE:
When the needle bearing is removed, always
replace them with a new one.
Assembling the reverse gear
1. Install the needle bearing.
60h60390
Checking the drive shaft
1. Check the drive shaft for bends or wear.
Replace if necessary.
60h60410
2. Measure the drive shaft run-out.
60h60415
3. Check the thrust bearing for run-out or
roughness. Replace if necessary.
NOTE:
Shimming is required when the thrust bearing
is replaced.
Checking the pinion gear
1. Check the pinion gear teeth for cracks or
wear.
60h60420
Run-out limit: 0.1 mm (0.0039 in)
Needle bearing attachment
1
:
90890-06612
Bearing depth plate
2
: 90890-06603
Driver rod SS
3
: 90890-06604
Содержание 200A
