Yamaha 02R, Руководство пользователя

Страница: 292 / 354

182 Installing Options
Digital Recording Console 02R User’s Guide
Wordclock Selection
1. Power on your ADAT modular digital multitrack recorder and then
the 02R.
It is always important to observe the correct order for powering up
equipment in a studio. Start with the ADAT and mastering recorders
and the signal processors, then the 02R, and finally the monitoring
amplifiers and other downstream gear.
2. Press the [DIGITAL I/O] button until the “Word Clock Select”
screen appears.
If the card was installed properly, the system software should correctly
identify it in the appropriate slot. The ADAT digital I/O card (CD8-AT)
can be installed in any slot. You should install the first two cards in
SLOT1 and SLOT2 in order to access the direct out lines.
3. Use the CURSOR buttons to select the wordclock source.
If you are using the 48kHZ OUT connector from the BRC ADAT
remote controller plugged into the WORD CLOCK – IN connector, use
the CURSOR buttons to select the W.CLK IN box and press the
[ENTER] button. If you are just using an ADAT modular digital
multitrack recorder, select the TAPE 1/2 box – the first box in the
SLOT1 row – and press the [ENTER] button.
4. When you select the wordclock source, the appropriate icon
should be inverted in reverse video.
See “Word Clock Select” on page 154 of the User’s Guide for further
details.
Note: If the W.CLK IN box or the TAPE1/2 box is not showing a proper
wordclock input (no discrepancy between the input and selected wordclock
frequencies), check the connections between the ADAT modular digital
multitrack recorder and the 02R.Check that the ADAT recorder is powered on.