52
R
e
p
e
a
te
r O
p
e
ra
tio
n
Repeater Operation
Repeater Operation
Communicating Via the Repeater
The transceiver includes an ARS (Automatic Repeater
Shift) function which enables repeater operation
automatically when setting the receiver to the
repeater frequency.
1
Set the receiver frequency to the repeater
frequency.
“ ” or “ ” appears on the left side of the frequency
whereas “TN” and the tone frequency appear on the
right side of the frequency.
2
Begin transmitting by pressing and holding . The
transmitter will automatically be set to the programmed
offset frequency and CTCSS tone.
Tips
• Touching
[F MW]
followed by
[REV]
enters the “reverse” state where the transmission frequency and
the receive frequency are temporarily reversed. This allows checking to find if direct communication
with the remote station is possible.
• In the “reverse” state, “ ” blinks on the LCD.
• Touching
[F MW]
followed by
[REV]
again exits from the “reverse” state.
• Press and hold
for over one second to enter Set mode, then configure the following repeater
settings for more convenient use.
[CONFIG]
[14 RPT ARS]
: Deactivates the ARS function.
[CONFIG]
[15 RPT SHIFT]
: Allows setting the repeater shift direction.
[CONFIG]
[16 RPT SHIFT FREQ]
: Allows changing the repeater shift offset
