Yaesu FT-2000D, Руководство по эксплуатации

Страница: 86 / 140

Page 84 FT-2000D O
PERATING
M
ANUAL
A number of interesting and useful features are available during Electronic Keyer operation.
Setting the Keyer Weight (Dot/Space:Dash) Ratio
The Menu may be used to adjust the Weight for the built-in Electronic Keyer. The default weighting is 3:1 (a dash is
three times longer than a dot or space).
U
SING THE
B
UILT
-
IN
E
LECTRONIC
K
EYER
CW M
ODE
O
PERATION
1. Press the [
MENU ] button to enter the Menu mode.
2. Rotate the Main Tuning Dial knob to select Menu
item “ 062 A1A WEIGHT .”
3. Rotate the [ SUB VFO-B
] knob to set the weight
to the desired value. The available adjustment range
is for a Dot/Space:Dash ratio of “
2.5 2.5 2.5 2.5 2.5
” ~ “
4.5 4.5 4.5 4.5 4.5
” (de-
fault value: “
3.0 3.0 3.0 3.0 3.0
”).
4. When you are finished, press and hold in the
[
MENU
] button for two seconds to save the new
setting and exit to normal operation.
Main Tuning Dial Knob
[SUB VFO-B] Knob
[MENU] Button
Selecting the Keyer Operating Mode
The configuration of the Electronic Keyer may be customized independently for the front and rear KEY jacks of the
FT-2000 . This permits utilization of Automatic Character Spacing (ACS), if desired, as well as the use of the
electronic keyer via the front jack and a straight key or computer-driven keying line via the rear panel.
1. Press the [
MENU
] button to enter the Menu mode.
2. Rotate the Main Tuning Dial knob to select Menu
item “ 054 A1A F-TYPE ” (for the front KEY jack)
or “ 056 A1A R-TYPE ” (for the rear-panel’s
KEY
jack).
3. Rotate the [ SUB VFO-B
] knob to set the keyer to
the desired mode. The available selections are:
OFF OFF
OFF OFF OFF
: The built-in Electronic Keyer is turned off
(“straight key” mode).
buG buG buG buG buG
: Dots will be generated automatically by the
keyer, but dashes must be sent manually.
ELE ELE
ELE ELE
ELE
: Both dots and dashes will be generated au-
tomatically when you use your paddle.
ACS ACS
ACS ACS ACS
: Same as “
ELE ELE
ELE ELE ELE
” except that the spacing be-
tween characters is precisely set by the keyer
to be the same length as a dash (three dots in
length)
4. When you are finished, press and hold in the
[
MENU
] button for two seconds to save the new
setting and exit to normal operation.
Main Tuning Dial Knob
[SUB VFO-B] Knob
[MENU] Button
Inter-character
spacing to short
Morse
“E” & “T”
Morse
“E” & “T”
ACS “ON”
ACS “OFF”