Yaesu FT-2000D, Руководство по эксплуатации

Страница: 102 / 140

Page 100 FT-2000D O
PERATING
M
ANUAL
M
EMORY
O
PERATION
S
TANDARD
M
EMORY
O
PERATION
The Standard Memory of the FT-2000D allows storage and recall of up to 99 memories, each storing frequency, mode, and
a wide variety of status information detailed previously. Memories may be grouped into as many as six Memory Groups,
and additionally you get nine pairs of band-limit (PMS) memories along with five QMB (Quick Memory Bank) memories.
[A
X X
X X X M] Button
[SUB VFO-B] Knob
[V/M] Button [A/B] Button
[GRP] Button
[M CH] Button
[SUB VFO-B] Knob
Memory Storage
1. Set the Main band (VFO-A) up with all frequency,
mode, and status the way you want to have it stored.
2. Press the [
A
X X
X X X
M
] button momentarily (the current chan-
nel number will start blinking in the multi-panel win-
dow); the contents of the current memory channel will
be shown on the Sub band (VFO-B) display field.
3. Rotate the [ SUB VFO-B
] knob to select the memory
channel onto which you wish to store the data. If you
have selected a channel on which data is already stored,
that frequency will appear on the Sub band’s (VFO-B)
frequency display field.
4. Press and hold in the [
A
X X
X X
X
M
] button for two seconds
to store the frequency and other data into the selected
memory channel. A double beep will confirm that you
have held the [
A
X X
X X
X
M
] button in long enough.
Memory Channel Recall
1. Press the [ V/M
] button, if necessary, to enter the
Memory mode. A memory channel number will ap-
pear in the multi-panel window.
2. Press the [
M CH
] button. The Red LED inside the but-
ton will light up, indicating that you are ready to recall
a memory channel.
A
DVICE
:
If the Red LED imbedded in the [ M CH
] button does
not light up, check to be sure that the orange lamp to
the right of the [
SUB VFO-B
] knob is not illuminated.
If it is, press the [ A/B
] switch to make it go out, then
press the [ M CH
] button again.
3. After pressing the [
M CH
] button, you may rotate the
[
M CH
] knob to select the desired memory channel.
A
DVICE
:
To work within a particular Memory Group, press the
[
GRP
] button (the imbedded LED will glow Red), then
rotate the [ SUB VFO-B
] knob to select the desired
Memory Group. Now press the [
M CH
] button (the im-
bedded LED will glow Red); you may now choose the
memory channel within the selected Memory Group.