50
XYZ Machine Tools
ProTURN SLX 1630 ProtoTRAK SLX CNC Safety, Installation, Service & Parts List Manual
Your input
Display
Data displayed.
X +
X
Motor encoder reading
Z
Nothing (should be 0)
Feedrate
the maximum feedrate attained
Your input
X
Motor encoder reading
X -
Z
Nothing (should be 0)
Feedrate
the maximum feedrate attained
Your input
X
Nothing (should be 0 )
Z +
Z
motor encoder reading
Feedrate
the maximum feedrate attained
Your input
X
Nothing (should be 0 )
Z -
Z
motor encoder reading
Feedrate
the maximum feedrate attained
Interpretation of the resulting values displayed:
The values for the encoder displays should be in the range of 76 mm to 127 mm.
If the motor encoder value is not within specification it may be the problem. If
the encoder is not reading then it will need to be replaced.
The feedrate should be a minimum of 180 ipm for X, and 120 ipm for Z. Shops with
higher voltages will see higher values.
If the feedrate is less than 4572 mm/min (180 ipm) and inconsistent in both
directions, check the incoming AC voltage and mechanics of the drive train.
4.8.2.3 CODE 123: Calibration
See Section 5.22 for a further explanation of this code.
4.8.2.4 CODE 127 - Set X or Z Backlash Constant
See Section 5.22 for a further explanation of this code.
4.8.2.5 CODE 128: Input Backlash Constant
Code 128 allows you to enter the backlash values for each axis. It displays the value
after it enters. This code is only used on machines with motor encoders only.
4.8.2.7 Code 308: Reverse X Hand Wheel Direction
This service code reverses the direction of the X hand wheel.
4.8.2.8 Code 310: Reverse Z Hand Wheel Direction
This service code reverses the direction of the Z hand wheel.
