Xyratex RS-1600-FC-SBD, Инструкция по установке и эксплуатации

Страница: 55 / 82

Operation
41
Chapter 3
Operation
3.1 Before You Begin
Before powering up the enclosure please ensure that all the modules are firmly seated in their correct
bays.
3.2 Power On
Caution Do not operate this equipment until the ambient temperature is within the specified operating range. If the
drives have been recently installed ensure they have had time to acclimatize before operating them.
Note Please refer to Section 3.3 for details of the Ops Panel LEDs and related fault conditions.
Follow the procedure below to Power On the enclosure.
1 Apply AC power to the enclosure. Turn the Power Supply modules to ON.
2 On the Ops Panel, the Audible Alarm beeps once, all LEDs flash for 7 seconds then the Alarm double
beeps.
3 All LEDs on the Ops Panel should be lit (Green) when the enclosure power is activated (and the disk drive
motors should start).
Note All LEDs on the Ops Panel should be lit Green at power up to indicate that the system is functioning
correctly. If any show Amber then a problem exists and the procedure in
Chapter 4 should be followed.
Important If AC power is lost for any reason, on restoration of power the enclosure will re-start
automatically.