XY Powersports XY500UTV, Руководство по обслуживанию

Страница: 70 / 259

4. COOLING AND LUBRICATIING SYSTEM
4-6
I
nspection of Water Temperature Sensor
● Place a rag under water temperature sensor ① and
remove it from cylinder head.
● Check the resistance of water temperature sensor
as illustrated on the right. Connect the temperature
sensor
②
to the circuit tester, place it in a vessel
with engine oil. Place the vessel above a stove.
● Heat the oil to raise the temperature slowly and take
the reading from thermometer ③ and ohmmeter ④ .
Water Temperature and Resistance
Temperature( ℃ )
50 80 100 120
Resistance( Ω )
154±16 52±4 27±3 16±2
Installation: Apply a little thread locker and install it to
the cylinder head by tightening to the specified torque.
Water Temperature Sensor
Tightening Torque: 10N.m
● After installation, check the coolant level. Fill
coolant if necessary.
Inspection of Thermostat
● Remove thermostat case
● Remove thermostat
Note:
● Avoid sharp impact on temperature sensor
● Avoid contact of temperature sensor with
thermometer or vessel
4