XY Powersports XY500UTV, Руководство по обслуживанию

Страница: 203 / 259

11. ELECTRIC SYSTEM
11-6
INITIATING RELAY
●
PUT 12V TO THE SMALL TERMINALS;THERE IS
CONTINUITY BETWEEN THE LARGE TERMINALS.
●
IF THE START RELAY CONTACTS,SHOULD
MAKE A CLICKING SOUND.
●
WHEN POWER IS TAKEN AWAY FROM THE
SMALL TERMINALS,THERE SHOULD BE NO
CONTINUITY BETWEEN LARGE TERMINALS.
●
IF BOTH ABOVE TWO ITEMS ARE OK,IT
INDICATES THE RELAY IS OKAY.
ADJUST MULTIMETER TO DIODE GRADE.
●
USE MULTIMETER MEASURING STARTING
RELAY COIL RESISTANCE,IF THE VALUE OUT
OF THE SETTING RANGE, REPLACE WITH A
NEW ONE.
● ADJUST MULTIMETER TO 1X10 Ω
START AUXILIARY RELAY COILRESISTANCE:
3-5 Ω
START AUXILIARY RELAY, FULE PUMP RELAY
●
APPLY 12VOLTS TO THE TWO TERMINALS.USE
MULTIMETER MEASURE IF CONTACTS A,B IS MEET.
ADJUST MULTIMETER TO DIODE GRADE.
●
IF THE STARTING RELAY CLICKS .
●
WHEN NON-LOADED 12V VOLTAGE,THE TWO
CONTACTS UNCONNECTED.
●
EITHER OF THE ABOVE TWO ITEMS IS SHOWS THE
RELAY IS FINE.
●
ADJUST MULTIMETER TO 1X100 MEASURING
THE COIL RESISTANCE.
AUXILIARY RELAY COIL RESISTANCE:
90-100
Ω
ATTENTION:
AT THE BACK OF AUXILIARY RELAY,PARALLEL TO THE
DIODE DIRECTION, IT IS THE RELAY COIL’S ANODE.
WARNING:
RELAY VOLTAGE LOADED CANNOT EXCEED
2MINS,
OR ELSE,IT WILL CAUSE THE RELAY OVERHEAT