XtremeAIR XA41, Руководство по обслуживанию

Страница: 240 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page 4 Page date:
Chapter 72 25.09.2018
NOTE
NOTE
We recommend that you remove the oil lines from the oil valve end and not from the
engine end.
13. If necessary, remove the exhaust assembly (78-00-00), the manifold assembly
(71-01-00), the baffling and the fittings.
Be careful when you remove the engine. Make sure that the hoist is correctly balanced (with
or without propeller) to prevent damage.
14. Hold the engine at the two engine hoist points on top of the engine.
15. To disconnect the engine from the engine mount, disassemble the shock mount
connections, refer to chapter 71-20-00.
We recommend that you start with the top connections.
To install the engine:
If the wing is removed, install the lower fuselage longeron spacers first before you install the
engine. This will prevent damage to the fuselage. Refer to chapter 57-10-00.
Install the engine on the engine mount carefully. Do not cause damage to the installed
ignition cables and hoses.
1. Use an engine hoist and put the engine from the front side into the engine mount.
Make sure that you install the spacers supplied with the shock mount kits to prevent damage
of the shock mounts.
2. Install the lower bolts, washers, and shock mount kits. Safety the nuts with
approximately three turns.
3. Remove the load from the rear hoist point. Remove the rear strap, refer to Figure
72-3.
CAUTION
CAUTION
CAUTION
CAUTION