XtremeAIR XA41, Руководство по обслуживанию

Страница: 210 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page 2 Page date:
Chapter 55 25.09.2018
55-00-00 GENERAL
The XA41 and the XA42 have a standard empennage with stabilizers and movable control
surfaces.
The spars are made of carbon fiber rovings, carbon fiber mesh and foam cores. The
empennage shells are made of honeycomb sandwich with carbon-fiber laminate.
The vertical stabilizer is a part of the fuselage. A trim tab is attached to two hinge points on
the right side of the elevator.
All composite parts have different protective layers: a polyester layer, an acrylic filler and an
acrylic paint to prevent damage to the structure because of moisture and UV radiation.
55-10-00 HORIZONTAL STABILIZER
To remove the horizontal stabilizer:
1
Remove the rudder. Refer to chapter 55-60-00.
2 Remove the rear seat and the luggage compartment. Refer to chapter 25.
3 Remove the elevator. Refer to chapter 55-20-00.
4 Disconnect the elevator trim electric connector. Refer to Figure 55-1 and Figure
27-23.
5 Remove the safety wire from the stabilizer main bolts in the rear fuselage. Refer to
Figure 55-2.
6 Remove the stabilizer main bolts. (5/8” wrench). Refer to Figure 55-3.
7 Remove the horizontal stabilizer to the rear.
Figure 55-1: Electric trim connector
Figure 55-2: Safety wire lock of horizontal stabilizer main bolts