XtremeAIR XA41, Руководство по обслуживанию

Страница: 110 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page 8 Page date:
Chapter 27 25.09.2018
CAUTION
NOTE
Table 27-2: Control rod lengths [mm]
Control rod XA41 XA42
1- Elevator rod FWD
as necessary as necessary
2- Elevator rod CFRP
1835 1900
3- Aileron rod inboard
405 405
4- Aileron rod CFRP
1595 1595
5- Aileron rod outboard
as necessary as necessary
6- Trim tab rod
as necessary as necessary
Before you adjust the control system, examine the control rods, the bell crank levers and the
hinges for wear and damage. Make sure that the length of the control rods is correct. Adjust
the length, if necessary. Apply ACF-50 oil to the rod ends.
To adjust the length of the control rods:
1 Remove the access panels if necessary.
2 Remove the bolt that connects the applicable rod end to other parts. Refer to the
applicable section in chapter 27 for details.
3 Loosen the counter nut.
4 Turn the rod end until you get the correct length.
5 Measure the maximum adjustment length “L” of the rod ends, refer to Figure 27-6.
Make sure that a length equal to a minimum of 1.5 times of the diameter of the
screw is in the thread.
Make sure that the control system components do not touch the structure after you changed
the length of control rods. Incorrect adjustment of the control rods can cause injury
to persons or damage.
Make sure that the rod ends of the elevator control rod (1, Figure 27-5) are accurately
parallel. This will prevent damage to the casted housings of the rod end at full aileron
deflection.
6 Make sure that the rod end is correctly aligned.
7 Tighten the counter nut.
8 Assemble the removed connection parts.
9 Make sure that the controls move smoothly from stop to stop.
WARNING