XtremeAIR XA41, Руководство по обслуживанию

Страница: 128 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page 26 Page date:
Chapter 27 25.09.2018
27-30-00 ELEVATOR AND TRIM TAB
The elevator operates through push/pull rods, a bell crank and an actuator arm. The
actuator arm is part of the elevator. The push/pull rod that connects the actuator arm is
made of carbon fiber. The bell crank has a sealed ball bearing. For information on the bell
crank, refer to chapter 27-30-02.
The elevator is attached at six hinge points to the horizontal tail. The travel stops are in the
torque tube. Refer to Figure 27-3, position 15.
To remove the elevator, refer to chapter 55-20-00.
To adjust the neutral position and/or the deflection of the elevator:
1
Examine the control rods, bell crank levers and hinges for wear and other damage.
2 Measure the length of the control rods and adjust them, if necessary. Refer to Table
27-2.
3 Make the aircraft level, refer to chapter 08-10-00.
4 Hold the control stick in the neutral position.
5 Make sure that the elevator leading edge aligns with the leading edge of the
horizontal stabilizer (0° position).
6 If necessary, adjust the length of the elevator rod FWD to align the leading edges of
the elevator and the horizontal stabilizer.
7 Make sure that the elevator travel is in the permitted tolerances; refer to Table 27-1.
8 Replace the travel stops, if necessary.
9 Make sure that the control sticks move freely in the full travel range.