XtremeAIR XA41, Руководство по обслуживанию

Страница: 120 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page 18 Page date:
Chapter 27 25.09.2018
NOTE
To remove the rudder, refer to chapter 55-60-00
To adjust the neutral position of the rudder:
1 Remove the side inspection cover in the cockpit.
2 Remove the upper cowling, refer to chapter 71-10-01.
3 Remove the upper firewall inspection cover. Refer to chapter 71-30-00.
4 Turn the turnbuckle (XA42-2720-260) to release the tension in the rudder cable
control system.
5 To change the neutral position, change the length of the aft control cables and
middle control cables. Follow the necessary steps described in chapter 27-20-02
under “To install a set of assembled control cables”.
6 Assemble the aircraft in the opposite sequence.
To adjust the deflection of the rudder:
The deflection of the rudder is set to a constant angle. It is not possible to adjust it.
1 Make sure that the deflection tolerances agree with Table 27-1.
2 If the deflection is too large, and/or the rudder does not touch the stops, replace the
stops at the fulcrum lever (Figure 27-13, pos. 3).
27-20-01 Rudder Pedals
You can adjust the position of the pilot’s rudder pedals as follows: Pull the knob on the pedal
control rod and move the pedal to the necessary position. The knob operates a plunger.
When you push the knob, the plunger moves into a hole of the adjustment rod and locks the
position of the pedal.
Figure 27-14: Pedal adjustment
adjust the position
pull the knob