1. Turn on main power switch with bottles in place.
(Green switch located right side)
2. Push in to close quick release knobs.
3. With gas line on turn on spout switch and allow gas to
flow through the filling system.
4. Turn spout switch to middle position, and then back
up to full on position. Repeat this several times to
allow the purge path to ventilate completely.
5. Turn the release pressure knob at top of machine
clockwise to close valve about half way,
approximately ten turns.
6. Turn on the Pressure Release Switch (UP) for
maximum ventilation through the flow path.
7. When you are satisfied with the results turn off the
spout switch and remove the bottles.
8. Turn off the air/gas supply and remove all the hoses.
9. Turn off the machine.
Note:
Instead of using CO2, you can use an oil-free air
compressor as well.
265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | xpressfill.com | [email protected]
16
| XpressFill Systems LLC
Part Two
Attach cleaning hoses as pictured below. Hosing and connectors are supplied in the accessory packet.
