14.1.2.8 OpenVPN Server (ovpns)
269
When running multiple OpenVPN server interfaces, they must
either differ by protocol or by port.
IPv4 transfer network
This parameter determines the IPv4 pool assigned to clients. The network you
configure here must not be used otherwise. We recommend using a subnet from the
networks reserved for private use according to RFC 1918 (10.0.0.0/8, 172.16.0.0/12,
192.168.0.0/16).
If you are running multiple OpenVPN server interfaces, they all
must assign different address ranges.
The address pool size determines the maximum number of simultaneous connections
according to the formula: Number of addresses / 4 - 2 = number of connections. With
a netmask of 255.255.255.0 this yields 256 / 4 - 2 = 62 connections.
IPv6 transfer network
This parameter determines the IPv6 pool assigned to clients. The network you configure
here must not be used otherwise. We recommend spending a full /64 address block,
however smaller address blocks may be used here.
If you are running multiple OpenVPN server interfaces, they all
must assign different address ranges.
Access for selected certificates only
When enabled, only clients with a certificate listed below "Per-client setup" are allowed
to connect.
Published local networks
An OpenVPN client usually obtains the VPN network configuration from the server.
With this parameter you select the relevant local networks.
The client is not obliged to follow this suggestion. It may route
other network across the VPN.
Содержание SX-GATE
Страница 1: ...State 2016 12 13 V7 0 2 0 User Guide ...
Страница 92: ...12 1 Setup 92 There s no way to restore a purchased certificate without backup ...
Страница 126: ...12 3 3 Groups 126 12 3 3 C Usage This table show in which settings the definition is used ...
Страница 476: ...15 3 Apple iPhone 476 ...