Replacing the Pressure Roll Assembly
Caution
Make sure the press is powered off. Do not perform this replacement procedure with
the power on or electrical power supplied to the press. Allow the fuser to cool down for
50 minutes before performing any maintenance.
1. Perform the steps for
Removing the Fuser Module
.
2. Perform the steps for
Replacing the Stripper Finger Assembly
3. Once the Fuser Belt Assembly is out of the press and the stripper finger bracket
removed, you can access and remove the Pressure Roll Assembly:
a) Push down and release the front and back Bearing Holder Springs, and move
each spring into the holding position.
b) Install the Pressure Roll Handles under the bearings on each side of the roll.
c) Lift the Pressure Roll straight out of the press and place in an available box.
4. Install the new Pressure Roll Assembly. Use the Pressure Roll Handles to help position
the Pressure Roll in the Fuser Assembly.
5. Align the bearings to the cradle as you gently lower the Pressure Roll into place, and
then remove the handles.
6. Rotate the roll to ensure that the gears mesh properly.
7. Replace the Bearing Holder Springs to secure the Pressure Roll in place.
8. Ask the administrator to reset the High Frequency Service Item (HFSI) count for this
newly-replaced CRU component at the press Control Panel.
Related Topics:
9-23
Xerox
®
Versant
®
2100 Press
User Guide
Maintenance
Содержание Versant 2100
