Xerox Versant 2100, Руководство пользователя, Страница: 101 / 296

Note
The bypass connectors required for each fuser width type are located in the
Nationalization kit. To order additional fusers for this product, contact your Customer
Support Center.
Warning
Before performing this procedure, power off the press and allow 50 minutes for the fuser
to cool down. Always observe the warning labels inside the press.
1. If needed, ask the System Administrator to update the NVM width range settings
for the fuser at the press Control Panel and identify the specific width range of media
that can be run through the fuser.
Refer to the Default and Custom Paper Width Settings tables in the NVM Setting
procedure defined in the Common Settings section of the System Administrator
Guide. Always set the NVM settings before using the new fuser.
2. Open both the Left and Front Center Doors.
3. Locate the black fuser cover.
4. Remove the fuser cover by using the T10 Torx driver to unscrew the one mounting
screw at the center of the cover.
5. Locate the fuser identifier clip on the fuser assembly and, using a marker, write on
the identifier the fuser width being used.
9-29 Xerox ® Versant ® 2100 Press
User Guide
Maintenance