Configuring Trays 3 and 4 of the Tandem Tray Module
Trays 3 and 4 in the Tandem Tray Module are high-capacity paper trays. Configure Trays 3 and 4 to
support the paper in use.
If you are configuring the trays for the first time, configure them for the paper size that you need. If
you change the paper size, reconfigure the tray for the new paper size. For details on supported paper
sizes, refer to
Supported Standard Paper Sizes
.
To configure Trays 3 and 4 in the Tandem Tray Module:
Note:
Before you make any tray adjustments, compare the paper size to the current Tray 3 and
4 configurations. If the paper size matches the tray configuration, no tray adjustment is
needed.
1. Remove any paper from the tray.
2. Pinch the guide lock on the front paper guide, then slide the paper guide to the required paper
size.
3. To lock the paper guides into place, release the guide lock.
Note:
The paper guides lock into place only at the designated standard paper sizes.
Configuring Tray 6
Tray 6 is a dedicated high-capacity feeder. You can configure Tray 6 to support the paper size that
you will use. For details on supported paper sizes, refer to
Supported Standard Paper Sizes
To configure Tray 6:
Note:
Before you make any tray adjustments, compare the paper size to the current Tray 6
configuration. If the paper size matches the tray configuration, no tray adjustment is needed.
1. Remove the screw that holds the spacer plate at the back of the tray.
157