Xerox Phaser 6500, Руководство по обслуживанию

Страница: 347 / 793

Phaser 6500/WorkCentre 6505 Service Manual Xerox Internal Use Only 4-55
General Troubleshooting
Counter Clear
(ADF) Counter Clear (ADF)
■
Ready
■
Processing
■
Complete
Use to clear the ADF counter.
Parameter Parameter These functions read and write
parameters stored on the Image
Processor Board. Run this to configure
Scanner values manually.
Continue Illegal
■
Clear - delete data
■
Transmit - contents of
memory.
Specifies how to handle the
document data when the
transmission queue overflows
memory.
Thresh Memory
RX (%) Sets the percentage of memory
reserved when data is received. When
the remaining memory amount falls
below this threshold, data reception is
denied. Values range from 0 to 100.
The smaller the value, the larger data
storage capacity becomes.
Thresh
Immediate (%) Sets the remaining memory threshold
that triggers immediate output.
Immediate output refers to an
automatic image output to
accommodate incoming data that
exceeds memory capacity.
Values range from 0 to 99. The larger
the value, the sooner the immediate
output is initiated.
Thresh Memory
TX (%) Sets the percentage of memory
reserved when data is sent. Values
range from 0 to 100. The smaller the
value, the greater the available
memory for scanned documents.
Thresh GC (%) Sets the remaining memory amount
in the Flash file system for image data
storage that triggers garbage
collection.
Page Margin 1
(mm) Sets the page margin that allows a
larger-than-standard size document
to be handled as a standard size
document. The document is reduced
to the standard size by the set value.
Values range from 0 to 127. When the
value is 10, the margin is 10 mm.
Valid when the Discard Size setting in
Fax Setting is “Off”
Test Control Panel Display Test Description