Xerox Phaser 6115 MFP, Руководство по обслуживанию

Страница: 273 / 532

Phaser 6115MFP Multifunction Product Service Manual 8-3
Service Parts Disassembly
Fastener Types
The following table lists the primary types of Posi-Drive screws used to
assemble the printer. The procedures provide dimensional specifications for
screws being removed.
Caution
Use care when installing self-tapping screws in plastic. To properly start
the screw in plastic, turn the screw counter-clockwise in the hole until you
feel the screw engage the threads, then tighten as usual. Failure to
properly align or over tighten the screw can result in damage to previously
tapped threads.
Notations in the Disassembly Text
■
The notation “(item X)” points to a numbered callout in the illustration
corresponding to the disassembly procedure being performed.
■
The notation “PLX.X.X” indicates that this component is listed in the Parts
List.
■
Bold arrows in an illustration show direction of movement when removing
or replacing a component.
■
The notation “(self-tapping, plastic 10 mm)” or “(metal, 6 mm)” refer to the
type of screw being removed.
Note
Provides information specific to the replacement of parts or assemblies.
Posi-Drive Screw Types used in the Printer
Type Application Shape Characteristics
Self-
tapping,
plastic 1. Silver colored
2. Screw thread is coarse
compared to metal screw.
3. Screw tip is thin.
Self-
tapping,
plastic with
flange 1. Silver colored
2. It has a flange.
3. Screw thread is coarse
compared to metal screw.
4. Screw tip is thin
Sheet Metal,
silver 1. Silver colored
2. Diameter is uniform
3. Typically 6 mm in length
Parts etc Plastic
Coarse
Parts etc Plastic
Coarse
Parts etc Sheet metal