Xerox Phaser 6115 MFP, Руководство по обслуживанию

Страница: 139 / 532

Phaser 6115MFP Multifunction Product Service Manual 3-37
Error Codes and Messages
0040 Did not receive carrier signal within 6 sec. after sending CTR.
0041 Did not receive carrier signal within 6 sec. after sending PPR.
0042 Did not receive correct signal after sending RNR signal.
0043 Received incorrect signal at phase D in ECM mode.
0044 Did not receive carrier signal /FSK signal within 6 sec. after sending MCF in
ECM mode.
0045 Did not receive any correct signal after sending RNR response with ERR
signal.
0046 Receive incorrect signal when sending RNR response with ERR signal.
0047 Did not receive correct signal after sending ERR signal.
0048 Did not receive correct signal after receiving PPS_PRI_Q or PRI_Q,
EOR_PRI_Q.
0049 Did not receive correct signal after sending PIP/PIN signal within 13 sec.
004A Line energy over threshold lasts for 60 seconds after MCF and can not
detect FSK or carrier signal in ECM mode.
004B Can not detect correct FSK signal even though detected FSK tone within 6
sec.
004C Handshake fail during re-train or between page in V34 RX.
004E Receive DCN signal after sending DIS in V.34.
004F Remote side disconnected after sending ANSam in V.8 phase.
0050 Did not receive any correct signal after sending CJ signal in V.8 phase.
0051 Did not receive phase 3 signal after phase 2 within 20 seconds in V.34.
0052 Did not receive phase 4 signal after phase 3 within 20 seconds in V.34.
0053 Modem disconnect after phase 4 in V.34.
0054 Remote side disconnected after phase 4 in V.8.
0055 Receive incorrect signal after sending DIS signal in V.34.
0056 Modem disconnect after sending CFR in V.34.
0057 Did not detect image signal within 6 seconds after sending CFR.
0058 Did not detect image signal within 6 seconds after modem enter to primary
phase in V.34.
005A Modem can not detect any correct ECM frame within 3 minutes in phase C.
005B Did not detect phase 5 signal after primary channel within 6 seconds.
005C Detect busy tone within control channel after phase C.
005D Modem can not detect any correct ECM frame with 12 Sec in phase C.
005E Did not detect control channel signal after received RCP frame within 6
seconds.
005F Did not detect silence after sending JM signal for polling TX function.
0060 There are no bulletin files to be polled in V.34.
FAX Error Codes
Code Possible Causes of Error.