Xerox Phaser 6115 MFP, Руководство по обслуживанию

Страница: 140 / 532

3-38 Phaser 6115MFP Multifunction Product Service Manual
Error Codes and Messages
0061 Machine can not detect V.21 or V.8 signal within 35 seconds.
0062 Modem disconnect in phase D after our side sending out flag sequence in
control channel.
0063 Did not receive any flag sequence in control channel within 6 seconds in
phase D.
0064 Did not detect any control channel signal in phase D within 60 seconds even
though energy still on the line.
0065 Did not detect any control channel signal within 60 seconds after detect
silence in phase D.
0066 Did not receive T.30 signal or carrier signal after sending CFR in V.34.
0070 User presses stop key during receiving.
0071 Memory full during receiving.
Transmission Error Codes
Code Possible Causes of Error.
0080 Did not detect any G3 signal within 35 sec. specified by ITU-T in phase B.
0081 Received DTC signal in transmission phase.
0082 Transmitting unit receives a signal other than DIS or DTC. and DCN in
phase B.
0083 Detected FSK signal, but did not receive any signal within 35 seconds.
0084 Detect DCN signal in phase B.
0085 Transmitting unit sending DCS 3 times consecutively, but each time
responds with DIS/DTC.
0086 Detected response signal other than DTC, DIS, FTT, DCN or CFR after
sending DCS.
0087 Training attempt has failed because speed unit cannot adjust to low lower
speed.
0088 Received DCN signal after sending out DCS signal.
008B Receiver's protocol of DIS is received, but it is not compatible with our
machine.
008D Receiver's protocol of DIS is received, but remote side can't receive
document temporary, may be cause by run out of paper or other reason.
008E Remote side CSI number not defined in machine one touch or speed dial
directory.
008F Modem not ready to receive V.34 data during 6 seconds after receiving CFR
signal.
0090 Called side document not ready for our polling.
FAX Error Codes
Code Possible Causes of Error.