Xerox DocuPrint 305, Руководство пользователя

Страница: 81 / 169

4.2 Description of Menu Items
81
IPP
Select this to use IPP.
„
Port Status
Specifies whether to enable or disable the IPP port when the printer turns on. The default
is [Disable]. To use IPP, select [Enable] for this setting.
Note
• To enable the IPP port, IP address must be specified.
Important
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate
Memory].
„
Print Mode
*1 (refer to P. 95)
Specifies the print data process method (printer language to be used).
[Auto] (default)
Select this to make the printer automatically detect the printer language being used in the
data received from a computer and perform printing based on the detected data.
[PCL] [PS] [HP-GL/2] [TIFF]
Select this to process the data received from a computer as the specified data type. [PS] is
displayed only when the PostScript software kit (optional) is installed.
„
PJL
*2 (refer to P. 95)
This printer supports PJL commands that are independent from any printer languages. The
PJL commands are used to control print jobs and are required for printing using a printer
driver. In this menu, specify whether to enable or disable the PJL commands sent from a
computer. PJL commands allow you to specify the printer language to be used for the next
data even while the printer is using a different printer language at the time. Normally, it
should be set to [Enable]. The default is [Enable].
„
Access Control
Specifies whether to enable or disable the access right control when canceling/deleting a
print job or setting/releasing the printer to/from pause state. The default is [Disable].
„
DNS
Specifies whether to use the name registered in DNS (Domain Name System) in order to
recognize the printer. The default is [Enable], which means the DNS name is available. If
[Disable] is selected, the IP address is used for recognizing the printer.
„
Add Port No.
*3 (refer to P. 95)
Specify 0, 80, or a value between 8000 and 9999 for the additional port number. The default
is [80].
„
Connect Time-Out
Specifies the time interval for disconnection when no further data is received. You can
specify a value between 0 and 65535 seconds in increments of 1 second. The default is [60
Secs].
„
TBCP Filter
Specifies whether to enable or disable the TBCP filter when processing PostScript data.
This item is displayed only when the PostScript software kit (optional) is installed. The
default is [Disable].