Xerox DocuPrint 180, Руководство по настройке

Страница: 111 / 276

SETTING SYSTEM DEFAULTS
XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 5-7
Setting printer options
The following commands control the printing options for your
DocuPrint (some options may not apply to your printer configuration).
Use Set Option Help to display the available printing options and the
information you need to specify values.
Set Option
The Set Option command assigns values to the printing options you
specify. It may take a few minutes for an option to be set after you
enter the command. A Restart Sequencer command is the
recommended method for insuring that an option has been changed.
Access level Administrator
Syntax Set Option <name> <value>
Arguments <name> <value>
Specifies the name and value of the option you want to set.
Choose from the following:
AdjustX <offset> <units>
Sets the horizontal image shift from the edge of the paper
closest to the front of the printer as it is fed. “X” is the physical
slow scan direction. For example, for letter or A4 paper, “X” is
parallel to the short edge of the paper. For Ledger or A3, “X” is
parallel to the long edge of the paper.
<offset> is the amount of the horizontal image shift. The default
is 0. This value should normally be zero (0), but can be changed
to temporarily compensate for printer misalignments until a
service technician can adjust the printer.
<units> refers to the unit of measure used to specify the offset
value. The default setting is “mm.”
•
pt (points=72.27 to 1 inch)
•
bp (big point=72 to 1 inch)
•
pi (pica=12 points)
•
el (elite=10 points)
•
in (inches)
•
pu (pixel units =1/300 inch, not pixels)
•
fu (furlongs)
•
mm (millimeters)