Xerox DocuPrint 180, Руководство по настройке

Страница: 142 / 276

SETTING SYSTEM DEFAULTS
5-8 XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
AdjustY <offset> <units>
Sets the vertical image shift from the edge of the paper closest
to the front of the printer as it is fed. “Y” is the physical fast scan
direction. For example, for letter or A4 paper, “Y” is parallel to
the long edge of the paper. For Ledger or A3, “Y” is parallel to
the short edge of the paper.
<offset> is the amount of the vertical image shift. The default
is 0. This value should normally be zero (0), but can be changed
to temporarily compensate for printer misalignments until a
service technician can adjust the printer.
<units> refers to the unit of measure used to specify the offset
value. The default setting is “mm.”
•
pt (points=72.27 to 1 inch)
•
bp (big point=72 to 1 inch)
•
pi (pica=12 points)
•
el (elite=10 points)
•
in (inches)
•
pu (pixel units =1/300 inch, not pixels)
•
fu (furlongs)
•
mm (millimeters)
AllowElideHeaders <“TRUE” | “FALSE”>
Refers to the suppression of header pages within a group of
documents with the same sender name. The default setting is
“TRUE.”
AttributeNameForListDocs <attribute>
Refers to the text attribute to use for the List Documents
command. The default setting is “SenderName.”
BlueHighlight <RGB value for blue>
Refers to the RGB value for blue highlight color. The default
setting is “R: 0.0, G: 0.0, B: 0.8820001.”
For blue highlight color to print correctly, the default RGB (print)
value for this option should not be modified.
BrownHighlight <RGB value for brown>
Refers to the RGB value for brown highlight color. The default
setting is “R: 0.65, G: 0.1, B: 0.1.”
For brown highlight color to map correctly, the default RGB value
for this option should not be modified.
CardinalHighlight <RGB value for cardinal>
Refers to the RGB value for cardinal highlight color. The default
setting is “R: 0.7000001, G: 0.03, B: 0.1.”
For cardinal highlight color to print correctly, the default RGB
value for this option should not be modified.
CentsPerHeader <cost per sheet>
Refers to cost per header page. If you enter a value, the cost
information appears on the trailer sheet that prints at the end of
a job. The default setting is “0.0.”