10. Inspect the identified Print Head with the fault .
Note
Only perform this step if fault code XPE-09-61{xx} appeared. Otherwise continue with
the next step.
Action
Result
Tip
The face of the Print Head
has a mark as shown in the
The Print Head was impacted by the moving web. The Print
Head is very robust and is still in good working order even
after the impact with the web.
figure above due to an
impact from the moving
web.
Note
1.
Check the backer rolls in front of the marked Print
Head. If ink is present in this area, see
In the following step, do not
push the Marking Tower
back into the Printer as
instructed. It must stay in
that position for the
cleaning steps later on.
Note
If this problem occurs again after performing this
procedure, call Xerox for assistance.
2.
If ink is not present on the backer rolls in front of the
marked Print Head, see the
and select the appropriate procedure for the
side of the Marking Tower on which the Print Head is
located. Disregard the steps that call for a new Print
Head to be installed, as the existing Print Head will be
simply reinstalled into its original position on the PBU.
3.
Procedure complete.
Xerox
®
CiPress™ 325 / 500 Production Inkjet System
5-56
Customer Help Information
Problem Solving
Содержание CiPress 325
