Xerox CiPress 325, Информация для помощи клиентам

Страница: 182 / 192

3. Turn the Control Knob counterclockwise until it is completely loose to release the
Right Marking Tower and move into the Service position ( Figure 6 ).
Figure 6. Turning the Control Knob
4. Use the handle to completely pull out and extend the Right Tower.
5. Power down the print engine(s). Refer to the instructions.
Caution
Power off the CiPress
™
before removing or replacing a Print Head. Failing to power
off the CiPress
™
will cause damage to the Print Head and Print Box Unit and void the
Print Head warranty.
6. If needed, allow the Print Box Unit and print heads to cool approximately 15 minutes.
Note
If you have difficulty reaching the upper portion of the Tower to perform the following
task, use the Xerox-supplied maintenance platform.
Warning
Performing maintenance activities with arms above the shoulders can cause personal
injury. In addition, using ladders or elevation methods not designed for work on this
machine can result in injuries from loss of balance or bodily strain. Do not perform
maintenance on any part of the machine that is above shoulder height without using
a suitably-designed maintenance platform. A suitable design has a height of 20
inches and a top platform area that is at least 24 x 36 inches. These dimensions
ensure sufficient height for all users and also provide room to maneuver while
performing maintenance tasks.
7. Push Print Box Unit handles and lift latches.
8. Pull the Print Box Unit out until it stops at the Service position.
9. Attach the ESD wrist strap to your arm by sliding it over your wrist.
10. Plug the ground clip to the print bar.
• If this is a 4 Head Print Box Unit, attach the ground clip on the left side of the
print bar.
Xerox
®
CiPress™ 325 / 500 Production Inkjet System
7-10
Customer Help Information
Maintenance Tasks