WiOS
- 34 -
De-register Individual Handsets
To remove power from the base unit, unplug port 1
Reposition the dip switches as follows:
Handset 1
– Place switches 1 and 2 in the down position (On)
and switch 3 in the up position (Off).
Handset 2
– Place switch 1 in the down position (On) and
switches 2 and 3 in the up position (Off).
De-register Handset 1
De-register Handset 2
Re-plug port on into the base unit to restore power. During the de-
registration process the LED on the base unit will flash at a unique rate;
125 milliseconds on, 125 milliseconds off. The de-registration process will
take approximately five (5) seconds.
When the process is complete, remove power from the base unit by
unplugging port 1. Place the dipswitches back into the “Normal
Operation” mode, by placing all switches up or off position.
Because the de-registration process is initiated from the base unit, the handset
remains passive and will update once the de-registration process is complete. To
confirm that the de-registration process is successful, the de-registered handset(s)
will display:
((
))
PLEASE
REGISTER!
1 2 3
ON
1 2 3
ON
1 2 3
ON
WiOS
-
11 -
Quick Setup Guide
This section is designed to get the wireless handset on line quickly and easily, using
a brief outline format.
Installation
WiOS
is actually a full function key set without wires. Therefore, each unit requires
its own digital extension in the telephone system. The digital extensions are plugged
into the back of the base station, which is connected wirelessly with up to two (2)
handsets. Each telephone system can have a total of four (4) wireless handsets (2
base units, each with 2 handsets).
Getting Started
The base unit, handset, charging base and electrical plug come as a kit. Before you
begin, make sure that all of these items are in good working order. Not shown here
is the wall mount plate that gets mounted under the base unit and the belt clip that
attaches to be back of the handset.
