X8222r User’s Manual Version 1.0
- 38 -
2.9 Dynamic Routing
Click on the
Dynamic Routing
link in the navigation bar to view
the Dynamic Routing configuration table.
Enable RIP:
Check this checkbox to enable/disable RIP. RIP
should be enabled only if more than one WAN connection exists.
Protocol:
Select an RIP protocol (RIP v1, RIP v2, or RIP v1
compatible) from the drop-down list.
Direction:
Specify the direction (inward, outward, or both) for the
dynamic route.
Enable Password:
Check this checkbox to enable/disable the
password.
Password:
Enter the password in this field.
Click on the
Apply
button to complete the configuration. Please
note that configurations can only be permanently saved through
the
Maintenance
interface.
X8222r User’s Manual Version 1.0
- 39 -
3. System Settings
Click on the
System Settings
link on
the navigation bar.
This section includes
DHCP
Configuration
,
Management IP,
Firewall/NAT Services,
and
Modem
Setup
. Each section is described in
detail below.
3.1 DHCP Server
Click on the
DHCP Server
link in the navigation bar to view the
DHCP Server configuration table. The device can be configured
to perform as a DHCP Server and to enable data connection
between multiple PCs by configuring IP address ranges and
lease duration.
Server On:
Click this toggle button to enable the modem to
operate as a DHCP server.
Starting IP Address:
Enter the IP address that you would like
the DHCP server to start assigning addresses from.
Ending IP Address:
Enter the last IP address that you would
like the DHCP server to assign.
