EG102 User’s Guide
21
To configure the IP over Ethernet settings:
Select
“
Obtain an IP address automatically
” or “
User the following (fixed) IP
address
” and then also enter the
WAN IP address
and
WAN Subnet Mask
.
Select
“
Obtain default gateway automatically
” or “
User the following gateway
”
and then also enter the
gateway IP address
and
Use WAN Interface
where
packets will be sent to
.
Select
“
Obtain DNS server address automatically
” or “
User the following DNS
server addresses
” and then also enter the IP addresses of
Primary DNS server
and
Secondary DNS server.
Enter the DHCP Vendor Class Identifier (option 60) if necessary, DHCP server
uses this class ID to group clients with similar configuration needs within a
scope.
Check to Enable DHCP Vendor Info Extension (option 43) if necessary.
Click
Next
Figure 21: Network Address Translation Configuration
Global Settings:
Check
to
Enable NAT
if PCs in the LAN share the same WAN port IP address to
surf Internet
Check
to
Enable Firewall
if you need the device to do the first firewall protection
Check
to
Enable IGMP Multicast
Check
to
Enable WAN Service
Enter
the
Service Name
Click
Next
The
WAN Setup Summary
page shows all of parameters. Click
Save
if correct and
click
Back
to restart the configuration again.
