EG102 User’s Guide
19
PPP over Ethernet (PPPoE)
Figure 18: WAN Connection, PPPoE Configuration
To configure the PPPoE settings:
Enter the User’s PPP
Username
and
Password
Enter
the
Service Provider Name
if any
Select
the
Authentication Method
used during negotiation, default is AUTO.
Check
to
Enable Fullcone NAT.
The device will process all requests from the
same internal IP address and. port are mapped to the same external IP
address and port
Check
“
Dial On Demand
” if you do not need PPPoE connection always ON and
enter the timeout value to disconnect the PPPoE connection when connection
is idle and timeout. If you enter “0”, zero for the timeout value, it means always
ON.
Check the “
PPP
IP extension”
if your ISP requests to enable it, otherwise do not
select it. This is a special service to forward IP address assigned by remote to
the local device in the LAN.
Check the “Use Static IP address” and enter the IP address if your ISP assigns
a fixed IP address to you. Otherwise, do not select it.
Check the “Retry PPP Password on Authentication Error” if necessary
Check to “Enable PPP Debug Mode” to get more debug message for analysis if
necessary
Click
Next
