Network Installation
975-0298-01-01
2–9
•
Keep the alignment of wire pairs inside the sheath as straight as
possible.
•
Allow separation between data and power cables (data cables should
only cross a power cable at right angles).
•
Do not staple the cable with metal cable staples. Use appropriate
hardware fasteners to avoid damage to the cable.
The total length of the network, including all connected Xanbus-enabled
devices and the System Control Panel, cannot exceed 130 feet (40 m).
Xanbus cables are available in lengths from 3 feet (0.9 m) to 75 feet
(22.9 m).
Connecting Xanbus Cables
Follow these guidelines for connecting Xanbus cables to the System
Control Panel. The cables are connected to the System Control Panel at
the same time the System Control Panel is mounted. Read “Mounting the
System Control Panel” on page 2–11 before performing the following
procedures.
:
CAUTION: Equipment damage
Connect the System Control Panel only to other Xanbus-enabled devices.
Although the cabling and connectors used in this network system are the same as
Ethernet connectors,
this network is not an Ethernet system
. Equipment
damage may result from connecting a Xanbus system directly to a personal
computer.
CAUTION: Unpredictable device behavior
Do not connect one end of the network to the other to make a ring or loop.
Содержание XW-SCP 865-1050
