Installation
2–8
975-0298-01-01
Disadvantage
The disadvantage of the daisy chain layout is that
Xanbus-enabled devices cannot be removed from the network without
interrupting the network. To make the network function after removing a
device, you must connect the Xanbus-enabled devices on either side of
the missing device to each other or replace the device.
Guidelines for Routing the Xanbus Cables
To ensure maximum performance of your network, follow these
guidelines when routing the Xanbus cables. Route the cables before
installing the System Control Panel.
•
Route the cables away from sharp edges that might damage the
insulation. Avoid sharp bends in the cable—no less than a 4-inch
(100 mm) radius.
•
Allow at least 2 ¼ inches (57 mm) of space behind the wall to
accommodate the depth of the unit and allow room for the cables to
bend.
•
Allow for some slack in the cable tension.
Figure 2-6
Daisy Chain Layout
:
WARNING: Shock hazard
Do not route the Xanbus cables in the same conduit or panel as the AC and DC
power cabling.
System Control Panel II
Solar Charge Controller
Enter
Exit
System Control Panel
Charge
Controller
Automatic Generator Start
Hybrid Inverter
/
Charger
Gri d(AC1)
Gen (AC2)
Fault /
Warning
Equali ze
Battery
Chargi ng
Inverti ng
Flashing = sell
Inverter/Charger
Terminate the network at each end.
Содержание XW-SCP 865-1050
