Xantrex Truecharge TC1012, Руководство по установке, Страница: 49 / 74

Installing the Truecharge™ 2 Battery Charger
975-0402-01-01 2–17
This guide for use by qualified installers only
To connect AC wires with the crimp-on butt-splice connector:
a) Using a wire stripper, carefully strip 8 mm (5/16 in.)
from the ends of the two wires being connected.
b) Insert one wire into one end of the butt-splice, until
the insulation hits the internal metal crimp section,
insert the butt-splice into the crimping tool, and
crimp firmly. The proper location for the crimp is
approximately 1.6 mm (1/16 in.) past where the butt-
splice insulation tapers down as shown.
c) Repeat Step b for the other end of the butt-splice.
9. Slide the strain relief into the bottom half of the strain
relief retention hole in the charger.
10. When all connections are completed, push the wiring and
connectors inside the AC wiring compartment. Install the
wiring compartment cover and tighten the screw on top
to secure the cover. Do not over-tighten.
11. Proceed to “Mounting the Optional Remote Panel” on
page 2–24, if you have the optional remote panel
otherwise, proceed to “Mounting the Truecharge™ 2
Battery Charger” on page 2–18.
Important:
You must exercise care when crimping butt-splice
connectors. Use the crimp tool recommended by the manufacturer
for the connector used.
CRIMP TOOL
STRIP 5/16”
TC2 Series BattChg Install Guide.book Page 17 Monday, June 30, 2008 3:18 PM