Xantrex Communications gateway, Руководство по установке

Страница: 38 / 70

Configuration
3–8 975-0330-01-01
Using the Configuration Web Page
The configuration web page is divided into the following sections:
• Welcome—an introduction to the Gateway and the configuration web
page
• Home—entering your basic information and changing the password.
Se “Entering Your Basic Information” below. In the Home section
you can also rename inverters and other devices on the network.
• Network Configuration—configuring network parameters. See
“Configuring the Gateway for Your Network” on page 3–10.
• Wireless Configuration—configuring the Gateway to operate in
wireless mode. See “Configuring Wireless Mode” on page 3–12.
• Time Configuration—configuring network time protocol parameters.
See “Configuring Network Time” on page 3–14.
• Mail Configuration—selecting and configuring email sent by the
Gateway. See “Configuring Email” on page 3–16.
• Upgrade Device—upgrade the firmware of any Xantrex network-
enabled device in the system. “Upgrading Device Firmware” on
page 3–17.
CAUTION: Equipment damage
Use DeviceInstaller only to search for the Gateway IP address. Other functions
provided by the program can damage your Gateway.
Important:
Set Network and Wireless Configuration first. If the Gateway
loses connection with your computer or LAN due to a mis-configuration of
network or wireless settings, you must reset the Gateway to re-establish an
Ethernet connection. See “Resetting the Gateway to Factory Defaults” on
page 3–19. Because resetting the Gateway erases your configuration in progress,
you should first attempt to configure network and wireless parameters before
entering any other information. Once network and wireless parameters are
configured properly, configuring other fields will not cause any loss of
connection with your computer or LAN.