Page: 50
SmartPad LCD
© 2003 Xantech Corporation
Figure 32
– RC68+ Handheld Programmer Code Group
BANK TRACK CODE GROUP
When the SmartPad LCD™ is used in a system in conjunction with other controllers (i.e. Handheld remotes or
other SPLCD panels) in which the equipment can be controlled from multiple locations, the SPLCD panels have
the ability to track source selections simultaneously for in-sync operation with the current source selection.
i.e. If the user walks in a room and selects DVD on the SPLCD and then decides to select CD using a handheld
remote, the SPLCD will automatically switch to the CD source page. This works the same if multiple SPLCD’s
are used in a large room and a selection is made on one panel, the other panels will automatically switch to the
same source page currently selected.
The default Bank Track Code Group is
D8
.
STATUS LED SETTINGS
The Status LED (
Figure 2-3
) can be configured to track the STATUS line on the rear of the SPLCD (
Figure 3-
19C
). If this is desired the TRACK LED SETTINGS dialog box should be set to YES. The Default setting is NO.
When the TRACK LED SETTING is set to YES, the STATUS LED will turn ON whenever a positive voltage (5-
30VDC) is present at the STATUS Terminal on the rear of the SPLCD. Whenever this voltage is LOW (0VDC)
the LED will turn OFF.
This works in conjunction with the STATUS LINE role setting.
STATUS LINE ROLE SETTING
The Status Line on the rear of the SPLCD (
Figure 3-19C
) can be configured as either an
INPUT
to sense a
state of an external device or as an
OUTPUT
to control some external device.
INPUT
When
INPUT
is selected under the STATUS L:INE ROLE SETTING and a 5 to 30VDC signal is present on the
STATUS terminal on the rear of the SPLCD, the following event/actions can be triggered:
