X-Cite Exacte, Руководство пользователя

Страница: 5 / 58

1
X-Cite
®
exacte User Guide
035-00283 rev 3
1. X-Cite
®
exacte Message Reference
Display
Message
Definition Description
XXX
Intensity Setting (%)
Displays the iris setting, which gives relative intensity as
percentage of the lamp’s maximum output
XX.XX
Power Setting (watts)
Displays the power setting, which gives absolute
intensity in terms of watts
uXXX Power Setting (microwatts)
Displays the power setting, which gives absolute
intensity in terms of microwatts
X.XXX
or
XXX.X
Power Setting (milliwatts)
Displays the power setting, which gives absolute
intensity in terms of milliwatts
XXXX.
Lamp Hours
Displays the “hours of use” accumulated by the lamp
Flashing:
“
XXXX
”
Warming Up
The lamp is warming up. Warm up time is
approximately 4 minutes ref
section 6.1
bulb Lamp Error
Lamp installed incorrectly /
Lamp did not strike. See
section 10.3
cool
Lamp is too hot to strike
The lamp will automatically strike when it has cooled to
the optimum striking temperature. See
section 10.3
Alternating:
old / bulb
Old Lamp
The lamp has accumulated over 2500 hours. Lamp may
be near end of life.
Alternating:
end / bulb
New Lamp Required
The lamp has reached end of life. The lamp will not
strike.
LOC
Front Panel Locked
All front panel buttons have been locked to prevent
settings from being changed.
SFI
Shutter Failure
The shutter has failed to return to home position. Unit
should be restarted. If the error repeats,
contact Tech
Support .
E1
Lamp temperature is too high
Check ventilation filters and outlets to ensure that no
blockage exists. Restart unit and if problem persists
replace lamp. If problem continues
contact Tech
Support
E2
Internal communication failure Restart unit, if problem persists contact Tech Support
E3
Iris failed to go to home position Restart unit, if problem persists contact Tech Support
E4
Internal hardware failure Restart unit, if problem persists contact Tech Support
E5
Failure to communicate with Intelli-
Lamp
®
Check Intelli-Lamp
®
connection and restart unit. If
problem persists try another lamp, if problem still persist
contact Tech Support .
E6
Lamp self extinguished
Let system cool and restart lamp. If it goes out again,
replace lamp. If new lamp continues to self-extinguish,
contact Tech Support
E7
Internal system error Restart unit, if problem persists contact Tech Support
See Section 10 for troubleshooting.