12
•ATF Exchange
Fluid Top Up
Fluid Drain
Additive Load
• Enter quantity of fluid to be replaced, using and
confirm by pressing .
ATF Exchange
Amount:
10.0L
The presence of a minimum quantity of new fluid
in the tank ensures an immediate response from the
TranSERVE® pump, preventing dry operation,
which could cause slowdowns or air bubbles.
If the tank does not have a sufficient amount of new
oil, an error message will appear on the display.
Please check the
fluid level
• After you check the oil level, in the gearbox of the
vehicle, press . The following message will be
shown next:
Load cleaning
additive or
push ESC to skip it
• If you choose ESC (long press ), please see ”4.5 -
ATF exchange - Replacement cycle” on page 12.
4.4. ATF exchange - Cleaning
additive – Wynn’s Automatic
Transmission Flush
• To feed the cleaning additive,
unscrew the auxiliary tank stopper,
pour the liquid into the tank and
after that press .
⚠
The quantity of
additive or fluid to
be poured into the auxiliary tank
cannot be entered. The machine
will always inject all of the quantity
present in the auxiliary tank (from
zero to 3 litres). Immediately
after that, the TranSERVE® will
continue recirculating the old fluid
containing the cleaning additive for
ten minutes.
⚠
It is extremely important for
the operator to be already
sitting down in the driver’s seat
and to shift gear, selecting all of
the positions P – R – N – D – S,
keeping each position for about ten
seconds. This should be carried out
throughout the cleaning cycle.
⚠
Except for top-ups or
additive feeding, with every
other operation the TranSERVE®
will not start unless the fluid
temperature has reached at least
40 °C.
Fluid is too cold
wait for warmup
• Press .
30C
Waiting for fluid to
warm up...
After warming up, the TranSERVE® will then start
the additive feeding cycle, indicated on the display
by the following message:
Additive
NOTE: The injection of additives always takes
into account the exact quantity of fluid
contained in the delivery hose, and then the
TranSERVE® automatically adds the rest,
followed by the quantity of fluid, to ensure that
part of the additive does not remain inside the
hose.
New 13.5L
Used 1.0L
†0.0L Set 0.1L
• The cleaning cycle will then be started and run for
10 minutes.Operation in progress will be confirmed
by continuous flashing of the GREEN light.
Circuit Cleaning
Please wait... 00:09
4.5. ATF exchange - Replacement cycle
Below is a description of the operating phase
carried out by the TranSERVE® at the end of the
cleaning cycle and when the is long pressed
because no washing additive is added.
⚠
The TranSERVE® will not
start the replacement cycle
