8. DIGITAL INPUTS
8
Digital Inputs
8.1 S.BUS Input
The S.BUS input port can be used. It is a standard used for Futaba RC controllers. Only the rst version of S.BUS
is supported.
Mechanically, a common servo-wire like 3 pin jumper cable connector is used for S.BUS.
Figure 8.1 – S.BUS pinout - 3 pin servo cable.
Pin
Descrip on
1
GND
2
VCC 5V out
3
S.BUS in
Warning
: The +5V wire on the S.BUS input is intended for powering otherwise unpowered transceivers
and converters from WIRIS Agro. If your transceiver or convertor is powered otherwise, do
NOT
connect
the +5V wires and leave them unconnected instead, only connec ng the GND and S.BUS pins. If the +5V
wires are connected, damage of either device might occur.
S.BUS allows transmission of many servo-like channel PWM signals through a simple three pin connec on. The
device is compa ble with S.BUS enabled receivers and converters such as the Futaba SBE-1 PWM-S.BUS con-
verter.
E-mail and Web
[email protected]
www.workswell.eu
Mobile:
+420 725 877 063
ID:
Reg. No.: 29048575
VAT No.: CZ29048575
Headquarters
U Albrechtova vrchu 12
155 00, Prague 13
Czech Republic
Revision 1.0.0 EN, 25
th
Oct, 2019
All pictures are only for illustra on.
Real values may vary.
20