BA_WP_SPM2-1000_EN_28-22.docx
37
•
Now tension all elements by tightening the tensioning screw (
S
) with the appropriate Allen key.
•
Be sure to remove the Allen key from the spindle before switching on the machine.!
Increased risk of injury when starting the milling spindle if the Allen key is not removed!
•
Deactivate the spindle lock by pulling the adjusting wheel (
R
) and turning it back 90° to return the bolt (
B
) to
its original position
→
The spindle can now be turned manually again.
•
Turn the spindle manually to make sure that the milling tool does not hit or brush against anything. Now place
the table insert rings that match the tool diameter into the table top opening so that the distance between
the innermost ring and the milling tool is as small as possible.
Increased risk of injury if the table opening is too large or if the table insert rings are incor-
rectly selected!
•
Now set the desired spindle tilt using the handwheel (
17
) and the spindle height with the handwheel (
20
).
Then fix the set positions by tightening the clamping levers on the handwheels.
•
Then set the position of the safety fence (refer to section
16.1 resp.
16.2 depending on the fence used).
Important:
Make sure that the tool does not hit or brush against the safety fence by turning the milling spin-
dle by hand.
