BA_WP_SPM2-1000_EN_28-22.docx
34
10
Commissioning
Before commissioning, carefully read and observe this manual and the safety instructions in chapter
Before switching on, make sure that
•
the cutter is firmly and securely clamped,
•
there is no spanner left in the spindle,
•
the machine table and fence are clean and free of objects,
•
the guards are fitted in accordance with regulations,
•
the extraction system is connected and in good working order
•
and the direction of rotation is selected to suit the tool and work process.
10.1
Switching ON and OFF
The main switch (
1
) on the control panel is used to switch the machine's power supply on and off.
Switching ON
→
Turn the main switch to position “
I
”
Switching OFF
→
Turn the main switch to position “
”
After switching on the main switch (
1
), the speed set according to
the belt position is indicated by the corresponding signal lamp (
S
).
The speed setting is made according to chapter
Before switching on, make sure that there is no
spanner left in the spindle!
Figure 11: Control panel
10.2
Switching the spindle ON and OFF
•
To start the spindle, the main switch (
1
) must be switched on (position
“
I
”
).
•
First set the desired speed according to chapter
•
To
switch on
, press the green push button (
2
).
→
The milling cutter is set in rotation with the preselected speed and direction of rotation.
If the spindle is started without a tool, all the milling arbor rings and the clamping screw must
be fitted and tightened.
Do not start working until the machine has reached full speed (after approx. 10 s).
•
To
switch off
, press the red push button (
3
).
→
The milling cutter is switched off and brought to a standstill (braking time < 10 s)
Do not stop the spindle via main switch (1) or rotary switch (4), as the motor brake is not effec-
tive via these two switches! Do not switch the spindle on and off more than 10 times per hour!
10.3
Direction of Rotation Switch
The spindle direction of rotation is set via the rotary switch (
4
) on the control panel:
Conventional
→
Turn rotary switch (
4
) to the left (counterclockwise rotation, changeover only at standstill).
Climb milling
→
Turn the rotary switch (
4
) to the right (clockwise rotation, changeover only at standstill).
The signal lamp (
R
) indicates the dangerous direction of rotation
“
climb milling
”
.
Avoid simultaneous milling, as this considerably increases the risk of accidents!
1
2
3
S
R
4
5
