BA_WP_SPM2-1000_EN_28-22.docx
35
10.4
Emergency Stop Button
In the event of danger or malfunctions during operation, the machine can be stopped quickly and reliably using
the emergency stop button (
4
) on the control panel. Before restarting the machine, the emergency stop button
must be unlocked again.
The braking time of the motor to a standstill must not exceed 10 seconds.
11
Adjusting the Milling Spindle
Figure 12: Hand wheels for height / tilt adjustment
The tool height and spindle tilt are positioned via the two
handwheels at the front, which can be adjusted after loos-
ening the corresponding clamping lever (
K1
) or (
K2
).
•
Left handwheel (17)
Tilt adjustment in degrees
Range
: 90° … 45°
•
Right handwheel (20)
Height adjustment in mm
Range: max. 175 mm
11.1
Tilt Adjustment
•
Loosen the clamping lever (
K1
).
•
Set the angle with the handwheel (
17
) and read it off the angle scale (
18
).
•
After adjustment, tighten the clamping screw (
K1
) again.
11.2
Height Adjustment
•
Loosen the clamping lever (
K2
).
•
Preset the height by cranking the handwheel (
20
).
•
Then make the fine adjustment using the indicator (
19
).
•
After adjustment, tighten the clamping screw (
K2
) again.
Please note: In order to avoid possible spindle play, the height adjustment should always
be made from the bottom to the top.
17
20
18
19
K1
K2
